广西岩溶区金属硫化物矿床风化与元素表生迁移特征     

农毅平 《南方国土资源》1996,(3)

对广西岩溶区三个铅锌硫化物矿床风化带观测结果表明，中低山岩溶区硫化物矿床具有更强烈的风化淋滤作用，但次生晕面积较小；岩溶平原区硫化物矿床风化与元素表生迁移特征较相似于非岩溶区的情况，表现在可产生较宽的ｐＨ偏低带和较大面积的次生晕  相似文献   

元岭金矿蚀变破碎带特征及其找矿意义     

刘红樱  周顺之  胡受奚  王群昌 《河南国土资源》1996,(2)

根据对元岭金矿三条蚀变破碎带一般地质特征、微量元素特征的对比研究，并借鉴邻近矿区蚀变破碎带的矿化特征，本文阐明了元岭蚀变破碎带矿化的有利构造部位，总结了蚀变破碎带特征与矿化强度之间的关系，指出蚀变破碎带的矿化蚀变元素为中低温组合，矿化蚀变愈强则参与元素的种类愈多、数量愈大。围岩性质对矿化蚀变有一定影响，围岩中的易迁移亲铜元素和亲硫铁族无素对矿化有利。据此，为进一步成矿预测、评价蚀变破碎带的含矿性提供依据。  相似文献   

八庙—青山金红石矿床化学成分与成矿关系     

徐少康  李博昀  程建祖  刘振山 《河南国土资源》1996,(4)

本矿床是我国金红石矿床重要的成因及工业类型，为具有特定化学成分的岩石在特定变质条件下形成的。本文通过对大量数据的处理，查明了化学成分与成矿的关系：高Ａｌ２Ｏ３、ＭｇＯ、Ｆｅ２Ｏ３＋ＦｅＯ、Ｋ２Ｏ、Ｐ２Ｏ５、Ｈ２Ｏ＋、ＭｎＯ，低ＳｉＯ２、ＣａＯ、Ｎａ２Ｏ、ＣＯ２、Ｓ等，利于钛富集；高ＴｉＯ２、ＭｇＯ、Ｐ２Ｏ５、Ｓ，低ＳｉＯ２、ＣａＯ、Ｋ２Ｏ、Ａｌ２Ｏ３、Ｆｅ２Ｏ３／ＦｅＯ，利于金红石形成；高Ｓｃ、Ｚｒ、Ｎｉ、Ｚｎ及Ｌａ／Ｙｂ，低Ｙ、Ｎｂ、Ｔｈ、Ｃｄ、Ｂａ、Ｂｅ、ΣＲＥＥ，利于金红石纯度提高。对研究矿床成因及寻找新的同类矿床等有重要意义  相似文献   

金矿床的热液流体特征研究     

王建国  孙丽娜  赵玉山  侯根群  赵纯福 《国土资源》1993,(4)

通过对中国东部金成矿区域地质特征的分析,根据氢氧同位素及流体包裹体数据特征,表明中国东部金矿床成矿流体主要来自大气降水,其次为变质作用过程释放的水和岩浆分异水;成矿金属组分主要来自太古宙变质岩系。  相似文献   

桂西古侵蚀沉积间断面型金矿床(续载)     

陈开礼 《南方国土资源》2001,14(1):37-40

古侵蚀沉积间断面型金矿是桂西的主要金矿床类型。文章着重分析该类型金矿成矿地质条件 ,论述矿床成因及成矿机理 ,认为此类型金矿易采易冶 ,经济效益显著 ,建议加大开发力度。  相似文献   

Extreme Rainfall Events and Associated Natural Hazards in Alaknanda Valley, Indian Himalayan Region   总被引：2，自引：0，他引：2  

JOSHI Varun KUMAR Kireet 《山地科学学报》2006,3(3):228-236

Introduction The Himalaya is considered to be the youngest mountains on the earth, and is tectonically very active, and hence inherently (geologically) vulnerable to hazards. Extreme rainfall events, landslides, debris flows, torrents and flash floods due…  相似文献   

Alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands)     

MARC J.P. GOUW 《Sedimentology》2008,55(5):1487-1516

Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper.  相似文献   

Melting of the subcontinental lithospheric mantle by the Emeishan mantle plume; evidence from the basal alkaline basalts in Dongchuan, Yunnan, Southwestern China   总被引：3，自引：0，他引：3  

Xie-Yan Song  Hua-Wen Qi  Paul T. Robinson  Mei-Fu Zhou  Zhi-Min Cao  Lie-Meng Chen 《Lithos》2008,100(1-4):93-111

The Emeishan continental flood basalt (ECFB) sequence in Dongchuan, SW China comprises a basal tephrite unit overlain by an upper tholeiitic basalt unit. The upper basalts have high TiO₂ contents (3.2–5.2 wt.%), relatively high rare-earth element (REE) concentrations (40 to 60 ppm La, 12.5 to 16.5 ppm Sm, and 3 to 4 ppm Yb), moderate Zr/Nb and Nb/La ratios (9.3–10.2 and 0.6–0.9, respectively) and relatively high _{Nd (t)} values, ranging from − 0.94 to 2.3, and are comparable to the high-Ti ECFB elsewhere. The tephrites have relatively high P₂O₅ (1.3–2.0 wt.%), low REE concentrations (e.g., 17 to 23 ppm La, 4 to 5.3 ppm Sm, and 2 to 3 ppm Yb), high Nb/La (2.0–3.9) ratios, low Zr/Nb ratios (2.3–4.2), and extremely low _{Nd (t)} values (mostly ranging from − 10.6 to − 11.1). The distinct compositional differences between the tephrites and the overlying tholeiitic basalts cannot be explained by either fractional crystallization or crustal contamination of a common parental magma. The tholeiitic basalts formed by partial melting of the Emeishan plume head at a depth where garnet was stable, perhaps > 80 km. We propose that the tephrites were derived from magmas formed when the base of the previously metasomatized, volatile-mineral bearing subcontinental lithospheric mantle was heated by the upwelling mantle plume.  相似文献   

Carbonate aeolianites of western Saurashtra,India: experimental decipherment of the depositional mechanisms     

PRABIR DASGUPTA  SUBIKASH BANDYOPADHYAY 《Sedimentology》2008,55(5):1361-1374

Granular carbonate deposits of Late Pleistocene to Early Holocene age, commonly referred to as ‘miliolite limestone’, occur in a linear belt, parallel to the southern coast of Saurashtra, India. In the present study area these carbonate deposits are found in select valleys between ridges and mounds of pyroclastic material present in the Deccan trap plateau. Two different depositional histories have been proposed for these sediments. The presence of marine bioclasts led to the postulation of a marine origin for these deposits. The second school of thought propounded redeposition of the coastal sediments by aeolian processes. Although a few features could not be explained by the proposed aeolian model, critical comparison of these two views favoured the aeolian origin. The mode of occurrence, lithological and structural attributes, and microscopic evidence presented here, also support a possible aeolian origin for these deposits. Experimental observation indicates that these carbonate aeolianites represent backflow deposits, which accumulated because of the flow separation caused by the presence of topographic highs. The conspicuous concave‐up geometry of the deposit conformed to the shape of the separation bulb. In view of the inferred depositional mechanism, the disposition of the deposits and the signature of the palaeoflow direction suggest that the carbonate particles were derived from the north‐western coast of Saurashtra by strong south‐easterly winds. Massive granular carbonates with outsized basement clasts appear to be the product of avalanching of granular material from the higher contours because of oversteepening of the primary deposit.  相似文献   

Mapping Proterozoic unconformity-related uranium deposits in the Rockhole area, Northern Territory, Australia using landsat ETM+     

H.M. Rajesh   《Ore Geology Reviews》2008,33(3-4):382-396

The Rockhole area, Northern Territory, Australia, hosts a number of Proterozoic unconformity-related uranium deposits. The geology of the area features within Paleoproterozoic rocks of the Pine Creek Orogen, near the unconformity with overlying platform cover sandstone of the Paleo- to Mesoproterozoic McArthur Basin. Landsat Enhanced Thematic Mapper plus (ETM+) data was used in the Rockhole area to assist in mapping geological structures and lithology, and to identify anomalous concentrations of ferrous minerals, the product of alteration, which can be indicators of buried uranium mineralization. Several image-processing procedures were applied to the ETM+ data to identify, isolate and enhance mineralogical information as simple and complex false color composites. ETM+ 754 shown as red green and blue respectively was the best simple image. Overall, complex images based on Principal Component Analysis proved to be the most useful products. Sandstone, shale and siltstone, the target lithologies, Koolpin Formation, the target stratigraphic unit, and bleaching pattern due to the removal of iron(II) compounds, the target alteration pattern, were confidently mapped to provide information required by the mineral emplacement model, which ultimately identified areas of likely uranium mineralization. Thus the contrasting behavior of the two principle oxidation states of uranium and iron can be utilized to map/delineate bleached alteration zones associated with economic concentrations of uranium using multispectral sensors like Landsat or better hyperspectral sensors.  相似文献